linering.blogg.se - Plantronics hub download windows 7 professional

#PLANTRONICS HUB DOWNLOAD WINDOWS 7 PROFESSIONAL SOFTWARE#
#PLANTRONICS HUB DOWNLOAD WINDOWS 7 PROFESSIONAL PC#

To wear the headset on your other ear, rotate the boom upwards then twist it around so eartip is on other side before lowering boom.

Push in eartip and rotate to the right to lock it into place.

Push in eartip and rotate to the left to unlock it.

NOTE Your charge case has an internal battery and can fully recharge your headset twice while on the go before needing connection to a charge cable.

Attach charging device to USB wall charger or laptop for 90 minutes.

Align snap-fit magnetic areas of headset and charging deivce.

Your new headset has enough power to pair and make a few calls before charging is needed, though you may charge at any time. Charge and Fit Headset Three ways to charge your headset Once successfully paired, LEDs stop flashing red and blue and you hear “PC connected”.

#PLANTRONICS HUB DOWNLOAD WINDOWS 7 PROFESSIONAL PC#

Insert Bluetooth USB adapter directly into your PC USB port.Press and hold the Call button until you hear “Pairing”.In the event that your headset and Bluetooth USB adapter become unpaired do the following: During an active call, the Bluetooth USB adapter will flash blue. Place a call using Microsoft Lync or Microsoft Office Communicator.Go to Control Panel -> Sounds and Audio Devices, and in the Audio tab set the Plantronics BT300 as the default device for Sound Playback and Sound Recording. Go to Control Panel -> Sound-> Recording tab, and set the Plantronics BT300 device as the Default Communications Device. In the Playback tab, this is indicated by the green check mark. If you plan to listen to streaming audio set the Plantronics BT300 device as the Default Audio Device as well. Go to Control Panel -> Sound-> Playback tab, and set the Plantronics BT300 device as the Default Communications Device.

#PLANTRONICS HUB DOWNLOAD WINDOWS 7 PROFESSIONAL SOFTWARE#

NOTE Spokes software allows you to customize your headset’s behavior through advanced settings and options.Ĭonfirm the speaker and microphone settings for your PC softphone are set to Plantronics BT300. Load Plantronics Spokes software by visiting /software and click on the download button.NOTE Your Bluetooth USB adapter comes pre-paired to your headset. The LED remains solid blue when not on an active call. The LED will flash and then turn solid blue to indicate the headset is connected to the USB adapter.

NOTE Some phones may prompt you to allow access to contacts to enableĬaller name announcement. Once successfully paired, LEDs stop flashing red and blue and you hear “pairing successful.”.Press and hold the Call button until you hear “Pairing”.Pair another phoneĪfter pairing your headset to your phone you may want to pair another or new phone The call does not end when you remove your headset. End the call by pressing the call button.Make a test call from your mobile phone.Some phones may prompt you to allow access to contacts to enable caller name announcement. Once successfully paired, LEDs stop flashing red and blue and you hear “pairing successful”. If prompted by your mobile phone for a passcode enter 0000.While the headset LEDs are flashing red and blue, activate Bluetooth® on your phone and set it to search for new devices.While the headset LEDs are flashing red and blue, activate Bluetooth® on your phone and set it to search for new devices. Tap the Voice button and say “Pair mode,” or.Pair Mobile Phone and Call Pair your mobile phone Toggle the Volume button up (+) or down (–) during a call or while streaming audio. Tap the Mute button again to open the microphone and hear “mute off” confirmation.Ī 2-second press of the Play/ pause button will either pause or resume playback of streaming audio.ĭouble-tap the Call button. An alert repeats every 15 minutes as a reminder.